Daz Loader, Vista, Windows 7 and waking up from Hibernate

I have a CQ60-S420 laptop with Vista. The 32 bit Home Premium disk is here but I have not used it as I found this fine forum.

I tried Windows 7 x64 and was able to install and activate it just fine. I used Daz's loader. I can use the manual cert and key install as I am on SLIC 2.1 but I researched that after I had already used the loader.

Any how, I used to hibernate the laptop with Vista when the lid was closed. Since I installed and activated W7, when I open the lid and press the power button, the boot hangs with a blinking cursor. I have to press the power button again and that shuts off the laptop. Then I have to press the power button yet again which then resumes the PC normally.

This is happening in both my existing Vista and also in W7. So, my question is why is this happening? It only started after I installed Home Premium x64 in another partition.

I went through all the Hibernate posts on here but nothing matches my problem.

 

Yes. I intend to do that. But with dual boot, I am not sure how to remove the loader. I intend to format and reinstall W7 Ultimate with no dual booting. But ran into this problem while testing. So, is this due to the loader? If yes, I have another laptop that doesn't have SLIC in the BIOS at all (Toshiba A105-S1013) on which I intend to use the loader. Will I run into the same problem on that machine?

 

I haven't. But I figured I didn't need to. Besides, Vista does the same thing if I hibernate from Vista. So, this isn't just a W7 issue but rather what ever changed after I activatd W7 which is why I am wondering if its the loader and nothing should have changed apart from the boot loader for Vista.