Problem with activation vista on HP 550 :(

I have HP550 and vista loader works just fine.
Did you imported the right cert ?

 

You need to login to view this posts content.

 

Dont worry about the acces denied message.
Did you remove all other cracks with voatktools ??
If so, can you please make ACPI Scope report.
Install and open ACPI Scope and go to
File->Load ACPI Information-->From BIOS
Save it as ats file.
Again install VL and make another ACPI Scope report.
Upload both reports please.

 

It looks like VL didn't installed properly.
Do you see the VL text while booting ?

 

Uninstall all previous VL and then try with VL2.0
i have the same issue for my Dell....none of the latest VL work
I read somewhere on this forum suggest to use 2.0 and it works..

 

VL 2.1.2 works fine for me and I have the exact same model both with Free DOS.

 

I have no succes with approach written above..can't enter the command install hp in cmd prompt, it says "unknown command"

If i use the vl 3.0.0.1 and push hp i get error : ".....AppData\Local\Temp\RarSFX9\loader\Hewlett Packard\Hewlett Packard_BADGE.BMP=File not found! "

What is that?

 

You need to login to view this posts content.

 

hmmm, no success unfortunately

when i enter the command i get a success message, which is great but after restart still the remaining days in the control panel..crazy

 

Did you installed that file without a problem? (link)
And you sure that you removed any other installed cracks completely??
use VOATKTools and remove everything then reboot and try earlier steps

 

I don't know if it's installed properly, when i run it as administrator the command prompt was to be seen shortly and disappeared but no success message or something..
Woudl it be good to run the voatktools before entering the activation command?

 

first use the voatktools to remove all cracks and reboot..but if you have use other cracks not listed in the voatktools, best thing is to do a clean vista installation.
After reboot,
when that program runs, it ask where to install..then simply install it to C\: (no need to create a folder even..)

If it runs successfully reboot..

by the way, your pc, is it HP or something else??

 

Chana, thanks for assisting me with this but ..I'm stuck and think i have to buy a license or make a new installation tomorrow
I run voatktools, it runs for more then one hour now and i had to cancel, because this can't be normal(or is it?).
The Wow6 program wont start don't know why.
Yes, I have a HP550 notebook and did the procedure 2 days ago with my Dell PC with full success only HP refuses.

edit: Stupid mistake I made: unrared the wow file first (looked like a rar container), running it untouched helped , now I'm lucky
Thanks Chana and have a nice Sunday!

 

Hmm...no problem, glad i could help

yes, you better try out a clean vista installation and do the procedures i mentioned (then you wont need voatktools)

and NO voatktools does not take 1hour infact few seconds..dont unrar, run it and it asks what to do...

that 'wow' link specially works for HP and it sure works..try it on C\: drive any where, until it successfully works