Question about Daz' Loader

Discussion in 'Windows 7' started by LanderN, Feb 23, 2011.

Thread Status:
Not open for further replies.
  1. LanderN

    LanderN MDL Novice

    Feb 23, 2011
    3
    0
    0
    Hello,
    I'm using Windows 7 with RemoveWAT at the moment (I know RemoveWAT sucks, but I had never been flagged ungenuine untill now with Security Essentials. In the beginning I thought RemoveWAT was the most failproof solution)

    Anyway, with SP1 out, I know i will need to reactivate Windows 7.
    But now, I want to use Daz' Loader, so according to these forums I will have to do this:
    - Uninstall RemoveWAT with the official installer
    - Run WATFix from Daz'
    - Install Daz' Loader

    Now, my question: I have a very complex boot structure. I will try to explain: my Windows 7 installation is on a logical partition, computers can't boot directly to a logical partition, so the bootloader is located on a primary partition. On that same primary partition, Windows XP is installed. The bootloader on this primary partition can boot into Windows 7 AND Windows XP.

    Do I have to use "Preserve current boot code" to make sure I can still boot?

    Also, do I have to remove RemoveWAT and install Daz' Loader before I install SP1?
     
  2. triggat

    triggat MDL Member

    Feb 18, 2009
    192
    12
    10
  3. bdjfreestyle

    bdjfreestyle MDL Member

    Nov 24, 2009
    127
    10
    10
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...