Slic 2.1 and Failed activation

Discussion in 'Windows 7' started by Knall, Dec 12, 2009.

Thread Status:
Not open for further replies.
  1. Knall

    Knall MDL Novice

    Dec 12, 2009
    3
    0
    0
    #1 Knall, Dec 12, 2009
    I tried to find a similar issue on the boards and couldn't. I am sure its something I am missing but just can't find it.

    Here is the situation. I flashed my bios with Slic 2.1 gigabyte, added the gigabyte cert, the later I tried both manually, and using the opa tool. From there I have been unable to get windows to activate.

    Any suggestions?
     
  2. asphix

    asphix MDL Novice

    Aug 2, 2009
    3
    0
    0
    #2 asphix, Dec 12, 2009
    i mod my ga-p35-ds3r in isa-mode and worx like charme.try it...
     
  3. Knall

    Knall MDL Novice

    Dec 12, 2009
    3
    0
    0
    #3 Knall, Dec 12, 2009 (OP)
    sorry my TLA knwledge is sometimes lacking.

    isa-mode?

    the bios reports a successful 2.1 slic using slic toolkit. though the tool doesn't seem to recgonize the cert, maybe the cert install has failed? is there a way to verify?
     
  4. Knall

    Knall MDL Novice

    Dec 12, 2009
    3
    0
    0
    #4 Knall, Dec 12, 2009 (OP)
    Nix this. After reinstalling for the second time, running through everything manually it seems to finally have taken the Cert. That was what was causing the issues with the validation.

    Must have failed a manual step earlier during the process.

    Thanks for the reply.
     
  5. urie

    urie Moderator
    Staff Member

    May 21, 2007
    9,039
    3,388
    300
    #5 urie, Dec 12, 2009
    Ok problem solved i can close this post. :)