I have a studio 1537 and have updated to slic 2.1 previously on dell laptops it was as easy as getting an OEM disk and just installing with no activation. With this update is that exactly right or do I have to use the certs??? thanks
Sorry to jump in. Ive found a modded BIOS for my netbook on here (ASUS 1000HE) Is it correct I just need to flash with modded BIOS then insert key and cert? I have seen this can be done manually using command line or I could use the DAZ loader to insert them? Is it really that easy? I'm currently running the Daz loader but not with a BIOS mod. I would reinstall from scratch if I attempted the hard mod.
hmmm RW shows this 53 20 01 00 02 00 00 00 00 00 00 00 00 00 00 00 = 2.1 but if I open SLic DUMP 3.0 a window pops up in another language and if i press OK it says 53 20 00 00 00 00 00 00 00 00 00 00 00 00 = 2.0, BUT if I press NO then it says 2.1... hmmm any assistance would be great... also a link to the latest studio 1537 modded firmware.. i downloaded one and it seemed to work, but just incase... yes i have done searches for "studio 1537" and "dell 1537" etc,... i came across the one i downloaded, but also one from H10 that someone said bricked the laptop... so any assistance would be very helpful.. again thanks..
what is slic status .......... is it ok and green then or something else ....... run slic tool as an administrator tell me slic dump status on first window.....it should be ok go to advance tab and whats slic diagnosis box says ........ better u get a screen shot if possible
its correct but be sure there is chance that u might brick ur motherboard ..... so if u can bear the burn just give it a try ....... otherwise daz loader is safe ........ but before u play with ur bios and mods read all instructions and one of them i believe is to uninstall any loaders ........ any during these mods i had a os crash experience ..... but i am new like u so be prepared for the worst and then take leap ...... best of luck ..........