Also working here too! Have you noticed that the F11 and F12 options have disappeared in BIOS setup (F11 = Save CMOS to BIOS, F12 = Load CMOS from BIOS)? Also I can no longer find where to set the memory mode to Ganged as opposed to the current un-ganged. Any help would be highly appreciated. solracna
Code: Usage & Example for command line mode (AFUDOS & AFUWIN). Note: many of these options are advanced and can harm your system is used incorrectly. +---------------------------------------------------------------------------+ | AMI Firmware Update Utility Ver.4.xx | | Copyright (C)2007 American Megatrends Inc. All Rights Reserved. | +---------------------------------------------------------------------------+ | Usage: AFUWIN <ROM File Name> [Option 1] [Option 2]... | | or | | AFUWIN <Input or Output File Name> <Command> | | or | | AFUWIN <Command> | | ------------------------------------------------------------------------- | | Commands: | | /O - Save current BIOS into file | | /U - Display ROM file's ROMID | | /Ln - Refer to Options: /Ln | | /M - Refer to Options: /M | | /MAI - Disaply System ROM and ROM file's MA information | | /HOLE: - Update specific ROM Hole according to given name. | | NewRomHole1.BIN /HOLE:RomH1 | | /HOLEOUT: - Save specific ROM Hole according to given name. | | NewRomHole1.BIN /HOLE:RomH1 | | /D - Verification test of given ROM File without flashing BIOS. | | /EC - Flash EC firmware BIOS (Refer to OFBD Spec) | | /NCB - Flash NCB Area (Refer to OFBD Spec) | | /NCBOUT - Output NCB Data according to given name. | | Options: | | /P - Program main BIOS image | | /B - Program Boot Block | | /N - Program NVRAM | | /C - Destroy CMOS checksum | | /E - Program Embedded Controller Block | | /K - Program all non-critical blocks | | /Kn - Program n'th non-critical block only(n=0-7) | | /Q - Silent execution | | /REBOOT - Reboot after programming | | /X - Don't Check ROM ID | | /S - Display current system's ROMID | | /Ln - Load CMOS defaults:(n=0-3) | | L0: Load current optimal | | L1: Load current failsafe | | L2: Load optimal from ROM file | | L3: Load failsafe from ROM file | | /M - Update bootblock MAC address if it exists | | Example: /M1234ABCD will update MAC to 1234ABCD | | /R - Preserve ALL SMBIOS structure during NVRAM programming | | /ECUF - Update EC BIOS when newer version is detected. | | /SHUTDOWN - Shutdown after programming. | +---------------------------------------------------------------------------+ You could try /X switch