Failed flash, no display, computer fails to boot

Discussion in 'PC Hardware' started by JohnnyFeet, Aug 7, 2009.

  1. JohnnyFeet

    JohnnyFeet MDL Novice

    Jul 30, 2009
    8
    0
    0
    I have a ECS GF7050VT-M with a AMI BIOS and followed the instructions in the sticky to add certificates, SLIC 2.1, etc. It successfully modified using the tool and I flashed using the manufacturer's recommended utility in Windows. The flash stated that it went successful and stated to restart the computer. After clicking restart, the computer turned off, but failed to turn back on. I tried turning it back on, internals turn on for about 5 seconds, and then the computer fails to boot. There is no display either.

    What does the problem sound like? Any suggestions/tips for fixing it?
     
  2. urie

    urie Moderator
    Staff Member

    May 21, 2007
    8,692
    3,046
    300
    #2 urie, Aug 8, 2009
    Last edited by a moderator: May 23, 2017
    Please read bios recovery section http://forums.mydigitallife.net/threads/2105
    Also you should if possible flash from dos it is safer