what am i doing wrong? Used flas**t under dos with /all param. but after reboot, it`s slic 2.0! what does this mean in slic dump toolkit: chksum: 86 Status: Dump OK! (But SLIC OEM Table Error!) anyone knows?
Hex compare with what?? Looks like you pick a wrong bios fd file for dos flashing... try to flash with the original bios (not modded) first... see if you can fix the error... In your case here, you got 3 bios files... usually the insydeflash program detecting your mb then flashing with the right bios file.. So use the original bios then run the exe files... then the sp***.exe must be extracted to somewhere on system drive.. you just have to open in the platform.ini file which fd file is written in the FileName = entry... note that down since that is the bios for your mainboard... Once your bios is recovered without error then you can proceed with dos flashing with the correct bios file that you noted down... Hope all goes well for you
I didn't quite understand your post... The bios files is the 3 FD files which is 30F3F2A.FD, 30F4F2A0.FD and 30F4F2A1.FD so i guess the 30F4_new is some left over which accidentally included there... The important thing here you must know which is the right BIOS for your board between the 3 files... since I don't have insyde bios laptop now, I'll try to describe it roughly for you.. You can see there's a platform.ini right? Open it and you find entry : [FDFile] FileName=XXXX.FD BackupName= What you need is to run the flash program so you can find out which bios file loaded and used between 3 FD files... If you can track that down then you use the correct file to flas**t from dos with the /all parameter