Try this: full format the pendrive with filesystem FAT32 Put the original biosfile on it, rename it to R2060Q2.BIN Disconnected the AC adapter from the notebook. Remove the battery from the notebook. Insert the USB thumb drive into one of the USB ports on the notebook. Held down the 'Windows' Key and the 'B' key. Connect the AC adapter. Press the 'Power' button on the notebook. When the LEDs come on, let go of power button and the two keys held down earlier. After about 10 seconds the notebook starts to read the USB thumb drive. While searching for the file the notebook may beep once a second. If the file was not found, the notebook will reset itself and try again. If the file was found then it shouldnt take more than 30 seconds to load the file. No beeping sounds are heard during the loading time. When the file has loaded, the notebook starts flashing the bios file. This is indicated by beeps every 2 seconds. This takes about 30-60 seconds. About 5 seconds after the beeping stops the notebook will automatically shut itself down. Switch on the notebook again.
I did it as you wrote but nothing happend. Formated pendrive FAT32 + R2060Q2.BIN --> When I press buttons as you described notebook try to boot as ussall to harddrive to windows. It doesn't check a pendrives files