Thank you for your quick reply. I am confused by your last sentence. What I think I am supposed to do is simply flash the $image2M.usf file in your link with winphlash with the settings you said. Is that correct? I was confused as to why I would upload another RW everything report since I have already uploaded one. The files you linked already have the mod, correct?
bios is $image2M.usf after you flash bios mod, rw will change. And I want you upload to it after flashing bios mod
Isn't this what I just did? When you say bios original do you mean the original bios I linked in my request post. Which bios are you referring to as bios mod? Do you mean the bios in the file you just linked ( $image2M.usf )? Tell me if these steps are wrong and I am misunderstanding you please. 1) flash the original factory bios with your "flags" set (the bios I have linked in my initial request post), reboot 2) flash the bios that you just linked ( $image2M.usf ) with your flags set, reboot 3) perform another RW report, upload again, and then flash which file?
ok. I flashed the original bios per instructions then rebooted. Then I flashed the modded bios and reboot; however, now I can't get it to completely post. I cleared the cmos a couple of times trying to get it to work. After I clear the cmos using the jumper, I can enter the bios but I can't figure out any changes that will actually let me boot into windows. After my changes, it normally starts to post then restarts and hangs on initial lenovo screen. It may take me a while to figure this out. This lenovo bios doesn't have the normal settings I am used to in the bios that allow you to configure boot sequence and which errors to halt on. I will reply if I can figure out how to get it to boot back into windows and I will include a new RW report.