I flash from DOS with C:\>AFUD4310 A7280AMS.190 /p /n /c this dont work: C:\>AFUD4310 A7280AMS.190 /n /pnc +---------------------------------------------------------------------------+ | AMI Firmware Update Utility v4.31B0 | | Copyright (C)2009 American Megatrends Inc. All Rights Reserved. | +---------------------------------------------------------------------------+ - Error: Unknown command C:\>AFUD4310 +---------------------------------------------------------------------------+ | AMI Firmware Update Utility v4.31B0 | | Copyright (C)2009 American Megatrends Inc. All Rights Reserved. | +---------------------------------------------------------------------------+ +---------------------------------------------------------------------------+ | Usage: AFUDOS <ROM File Name> [Option 1] [Option 2]... | | or | | AFUDOS <Input or Output File Name> <Command> | | or | | AFUDOS <Command> | | ------------------------------------------------------------------------- | | Commands: | | /O - Save current BIOS into file | | /C - Refer to Options: /C | | /U - Display ROM file's ROMID | | /S - Refer to Options: /S | | /Ln - Refer to Options: /Ln | | /M - Refer to Options: /M | | /MAI - Disaply System ROM and ROM file's MA information | | /HOLE: - Update specific ROM Hole according to given name. | | NewRomHole1.BIN /HOLE:RomH1 | | /HOLEOUT: - Save specific ROM Hole according to given name. | | NewRomHole1.BIN /HOLEOUT:RomH1 | <Press any key to continue> | /NCB: - Update specific Non-Critical Block according to given name. | | NewNcb1.BIN /NCB:Ncb1 | | /NCBOUT: - Save specific Non-Critical Block according to given name. | | NewNcb1.BIN /NCBOUT:Ncb1 | | /D - Verification test of given ROM File without flashing BIOS. | | /CLNEVNLOG - Refer to Options: /CLNEVNLOG | | Options: | | /P - Program main BIOS image | | /B - Program Boot Block | | /N - Program NVRAM | | /C - Destroy CMOS checksum | | /E - Program Embedded Controller Block | | /K - Program all non-critical blocks | | /Kn - Program n'th non-critical block only(n=0-7) | | /Q - Silent execution | | /REBOOT - Reboot after programming | | /X - Don't Check ROM ID | | /S - Display current system's ROMID | | /Ln - Load CMOS defaultsn=0-3) | | L0: Load current optimal | | L1: Load current failsafe | | L2: Load optimal from ROM file | | L3: Load failsafe from ROM file | <Press any key to continue> | /M - Update bootblock MAC address if it exists | | Example: /M1234ABCD will update MAC to 1234ABCD | | /R - Preserve ALL SMBIOS structure during NVRAM programming | | /ECUF - Update EC BIOS when newer version is detected. | | /SHUTDOWN - Shutdown after programming. | | /EC - Program Embedded Controller Block. (Flash Type) | | /CLNEVNLOG - Clear Event Log. | | /MEUF - Program ME Ignition Firmware Block. | | /ME - Program ME Entire Firmware Block. | +---------------------------------------------------------------------------+
@NoJuan999: Your version is working, thanks a lot! @Serg008: Your version unfortunately did not work - no SLIC table visible in Everest and activation failed. Anyway: Kudos to both of you for helping me that fast! Thx a lot!