"Sysprep error"

Discussion in 'Windows 7' started by avi hatotach, May 4, 2018.

  1. avi hatotach

    avi hatotach MDL Novice

    Oct 25, 2016
    11
    0
    0
    #1 avi hatotach, May 4, 2018
    I ran the sysprep software
    And I made a clone disk to another drive and I reboot
    But after booting I get an error
    "Windows could not finish configuring the system. To attempt to resume configuration, restart the computer"
    What is the solution to this?
     
  2. tcntad

    tcntad MDL Guru

    Oct 26, 2009
    4,677
    1,690
    150
    #2 tcntad, May 4, 2018
    Do it again but this time, make minimal changes..
    Windows Update, some basic apps. Id stay away from AV and FW. Dont update store apps!
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  3. Enthousiast

    Enthousiast MDL Tester

    Oct 30, 2009
    51,140
    110,603
    450
    #3 Enthousiast, May 4, 2018
    It's windows 7, what store apps?
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  4. tcntad

    tcntad MDL Guru

    Oct 26, 2009
    4,677
    1,690
    150
    #4 tcntad, May 6, 2018
    Store apps was just a tip if you'd sysprep W10 some day.
     
    Stop hovering to collapse... Click to collapse... Hover to expand... Click to expand...
  5. joluboga

    joluboga MDL Member

    Dec 4, 2011
    243
    121
    10
    #5 joluboga, May 6, 2018
    Did you by any chance, alter the time in the taskbar/control panel while in audit mode?