The one night i choose to go to bed at 9pm and sleep to 7pm and bam a leak oh well im dual booting this one with build 10122 till i know it has no bugs and till my dragon ball z torrent is done lol
.. It seems that this build has the oobe bug. It stucks on "one moment please..." EDIT: Just wait about 30 minutes and you can finally create a local account
After installing Windows 10 IP 10125, which I did to an new 750GB HDD as Main HDD in my Laptop and as I wrote in the other post that all went fine, I was need to enable the 2. HDD (which has build 10122 on it) manually via the Device Manager, which isn't OK! So, I checked in BIOS and found that SATA Mode were set ti IDE instead to AHCI. So I was need to set the SATA Mode to AHCI for to get Hot-Plug to work again because I change sometimes on the fly that 2. HDD with the DVD. So, question is: How to do that?! Many would know it but someone will may need to know the How Too......., special if he/she didn't like to reinstall Windows again! OK, here is the way I used for that: Open either an Command Prompt (CMD) as Administrator or Windows PowerShell as Administrator type the following command: Code: bcdedit /set {current} safeboot minimal Press Enter to excute the command Reboot the computer and go into the BIOS using th appropriate HotKey (Del./F1/F2/F10, depend on your BIOS) Windows will now boot in Safe Mode Open Command Prompt or PowerShell as Administrator again enter the following command: Code: bcdedit /deletevalue {current} safeboot Reboot your computer normally Now you'll have run the BIOS in AHCI Mode and could use also Hot-Plug. Just to note, the first above commands could also be used for to start Windows 10 IP in Safe Mode for other operation you may have to do. Also note, the same command could be used in Windows 8/8.1 but Windows 7!